TPL200 Pipe & Cable Locator Guide

The TPL200 is a multi-frequency locator with a 10-hour battery. This is what it receives, how to read it, and how it follows a push camera.

TPL200 at a glance

FeatureTPL200
Frequencies512Hz, 640Hz, 33kHz, power (50/60Hz), radio (6kHz to 22kHz)
SensitivityAdjustable 0 to 100, with a percentage signal display
BatteryBuilt-in lithium-ion, about 10 hours continuous
OutputSpeaker or headphones
Transmission range5 meters

Following a push camera

A sonde in the camera head transmits at 512Hz, and the TPL200 receives 512Hz. The Prowler Max and the PT Prowler Standard have the sonde built in, and every replacement camera head we sell includes one.

  • Push the camera into the line with the sonde transmitting.
  • Walk the surface above the pipe with the TPL200 set to 512Hz.
  • Raise or lower the sensitivity until the signal is clear, then mark the spot where it peaks.

Finding lines without a camera

The locator also receives power (50/60Hz) and radio (6kHz to 22kHz) signals. These bands pick up signals that are already present on some buried lines, so a camera or transmitter is not required for every search.

Questions

How long does the TPL200 battery last?

The built-in lithium-ion battery runs about 10 hours continuously.

Can I use headphones?

Yes. Output is through the speaker or headphones.

What does the sensitivity setting do?

Sensitivity adjusts from 0 to 100, and a percentage signal display keeps the reading clear.

Which push cameras can it follow?

Any camera whose sonde transmits at 512Hz, such as the Prowler Max and PT Prowler Standard, plus the replacement camera heads we sell.

Ready to shop?

Not sure what fits? Every Insight 360 order has a dedicated point of contact — get in touch.