What Is a Sonde, and How Do You Locate a Sewer Camera?

A sonde is a transmitter built into the camera head. A locator receives its signal so you can find the camera, and the pipe, from above ground.

What a sonde is

A sonde is a small transmitter that sends out a signal at a set frequency. Built into a push camera head, it lets you find the head from the surface while the camera is somewhere inside a buried pipe.

How you use it

  • Run the camera into the pipe with the sonde transmitting.
  • Walk the surface above the line with a locator tuned to the sonde's frequency.
  • When the locator reads the signal strongly, you are over the camera. Mark the spot to record where a defect or blockage is.

512Hz on our equipment

The Prowler Max and the PT Prowler Standard have a 512Hz sonde built in, and every replacement camera head we sell includes a 512Hz sonde.

The TPL200 pipe & cable locator receives 512Hz, 640Hz, 33kHz, Power and Radio signals, adjusts sensitivity from 0 to 100, and runs about 10 hours on its Li-ion battery.

Questions

What frequency is the sonde?

512Hz. That is the frequency of the sonde built into the Prowler Max and the PT Prowler Standard, and of every replacement camera head we sell.

Which Prowlers have a built-in sonde?

The Prowler Max and the PT Prowler Standard list a built-in 512Hz sonde. Replacement camera heads in 23mm, 33mm, 38mm and 50mm sizes include one.

What does the TPL200 receive?

512Hz, 640Hz, 33kHz, power (50/60Hz) and radio (6kHz to 22kHz), with adjustable sensitivity from 0 to 100 and a 10-hour battery.

Can I use a locator without a camera?

Yes. The TPL200 locates pipes and cables across its frequencies whether or not a camera is in the line.

Ready to shop?

Not sure what fits? Every Insight 360 order has a dedicated point of contact — get in touch.